The Cisco catalyseur 2960 série switches are reliable Layer 2 fixed configuration switches widely used in enterprise, campus, and branch networks....... KNon nonwn for stability and performance, they deliver secure connectivity for small to medium-sized networks. This guide provides a step-by-step walkthrough for performing password recovery on Cisco 2960 switches without losing configuration data.

Part 1: Password Recovery on Cisco 2960 commutateur

The following procedure helps you recover the enable mode password without losing the existing configuration file. Applicable to Cisco Catalyst 2950, 2960, and 2970 series switches.

Step 1: Connect Console Cable

Connect your PC or terminal to the console port using terminal software (PuTTY, TeraTerm, or minicom) voir aussi:.

Bits per second (baud): 9600

Data bits: 8

Parity: None

Stop bits: 1

Flow Control: Xon/Xoff

Step 2: Power Cycle with Mode Mode Button

Power off the switch. Press and hold the Mode button, then reconnect power. Release when the SYST LED changes from amber to solid green. The switch: prompt should appear in your terminal.

Step 3: Initialize Flash

switch: flash_init

Step 4: Rename Config File

switch: dir flash:

switch: rename flash:config.text flash:config.text.old

Step 5: Boot the System

switch: boot

When prompted for initial configuration dialog, typeno.

Step 6: Restore Configuration

commutateur> enable

commutateur#rename flash:config.text.old flash:config.text

commutateur#copy flash:config.text system:running-config

Step 7: Reset Passwords

Switch#Configurer le terminal

Switch(config)#enable secret NewP@ssw0rd

Switch(config)#line vty 0 15

Switch(config-line)#password NewVTYpass

Switch(config-line)#login

Switch(config-line)#line con 0

Switch(config-line)#password NewConsolePass

Switch(config-line)#fin

Step 8: Save Configuration

Switch#write memory

Part 2: Common Issues During Recovery

▪ Flash Not Detected: If dir flash: returns “no such device,” re-run flash_init or verify hardware model.

▪ MODE Button Reset Failure: Holding the button >10 seconds may disable management access instead of restoring it.

▪ Missing Config File: If config.text is missing or corrupted, configuration cannot be restored.

Part 3: Best Practices & Prevention Tips

▪ Use strong, complex administrative passwords with mixed characters.

▪ Regularly back up configuration file (copy running-config tftp:).

▪ Keep IOS updated to avoid firmware-specific password recovery issues.

▪ Document passwords securely and limit administrative access to trusted users.

Part 4: Conclusion

The password recovery process for Cisco Catalyst 2960 switches is straightforward when followed carefully. By renaming the configuration file before booting, you ensure that no network settings are lost during recovery. This procedure restores access to the device without requiring a full factory reset.

Cisco Catalyst 2960 Series Switches

Cisco All Series Switches New and Refurbished

For Cisco product list and quote, please visit: https://www.hi-network.com/categories/cisco or contact us at www.hi-network.com  (Email: info@hi-network.com)